Moving a group of components where no autowire is needed still causes autowiring. Schematic does not refresh correctly after closing the symbol/title block editor. Labview Microphone doesn't save or copy its Sample Rate setting. Labview intrument Signal Analyzer is not saving Interpolation Method. The shortcut key Ctrl-F does not open the find dialog window in the Description box editor.Īnalysis dialog should not allow selecting duplicate device/model parameters. Spreadsheet results tab go to arrows are out of sync with the circuit after a replace by HB operation. Goto location generated by confirming virtual connection is static.įootprint mapping for ADG413BRZ is incorrect. #NI CIRCUIT DESIGN SUITE 11.0 1 SERIAL NUMBER GENERATOR#The Temperature parameter in the resistor property pages does not validate out-of-range values correctly in some cases.Īgilent function generator does not model 50 ohm output impedence correctly.Īgilent oscilloscope vertical zoom can go up to 1nV/div. Word generator properties window resizes itself when changing display format. Printing an instrument over a wireless network takes a long time in some cases. Undo and Redo menu items are not translated in the Symbol Editor / Title Block Editor.Ĭonvergence Assistant doesn't use LabVIEW or ELVIS instruments. The pin mapping for the VGM96VC is incomplete. Two layers can improperly end up with the same layer name in some cases. The following is a subset of the issues fixed between Circuit Design Suite 11.0 and Circuit Design Suite 11.0.1 Multisim ( 112 )Ĭannot click finish in MCU wizard if the project type is load external hex file. These are actually called "Jump to next conflict" and "Jump to previous conflict". Circuit Design Suite Release Notes 11.0.2 state that the Forward Annotation and Backward Annotation dialogs have two new buttons called "Go to next conflict" and "Go to previous conflict".You can work around this by ensuring that your net names have preferred names that do not use those characters. Node names containing '/', '\' and ' ' will not work in the Postprocessor.To avoid these convergence errors, connect any of the remaining unused pins to ground. Push button double-pole single-throw switches can cause convergence errors if any of their pins are left unwired. The Beep function is used by this component to generate sound. This is due to Microsoft not supporting use of the Beep function in those versions of Windows.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |